ESL9000 Series Tape Library Memory Module - Upgrade Guide

Installing the Memory Module
14 HP StorageWorks ESL9000 Series Tape Library Memory Module Upgrade Guide
Removing and Replacing the Memory Module
To remove and replace the memory module:
1. Place the robotics controller on an anti-static mat and use ESD precautions.
2. Remove the memory module from the robotics controller as shown in
Figure 2.
Figure 2: Removing the memory module
3. Install the new memory module in the robotics controller (see Figure 2).
4. Re-install the robotics controller by reversing the steps in “Removing the
Robotics Controller” on page 13.
5. Reinstall the electronics bay cover.