HP StorageWorks Interface Manager and Command View TL Installation Guide (March 2005)
Table Of Contents
- Title
- Contents
- About this Guide
- 1: Introduction
- 2: Hardware Installation
- Preparing the Installation
- Installing the Expansion Cage in the ESL Series Library
- Installing the Fibre Channel Interface Controllers into the Expansion Cage
- Installing the Interface Manager Card into the Expansion Cage
- Connecting the Cables
- Connecting the Interface Manager Card to the Fibre Channel Interface Controllers
- Connecting the SCSI Bus Cables
- Connecting the Fibre Channel Cables
- Connecting the Interface Manager Card to the LAN
- Connecting the PC or Laptop
- Completing the Hardware Installation
- 3: Configuration and Software Installation
- 4: Troubleshooting
- A: Serial and Ethernet Pin Assignments
- B: Regulatory Compliance Notice
- Federal Communications Commissions Notice
- Harmonics Conformance (Japan)
- German Noise Declaration
- C: Electrostatic Discharge
- D: Specifications
- Index
Introduction
17Interface Manager and Command View TL Installation Guide
External Features Overview
Figure 3 and Table 2 identify the I/O components of the Interface Manager card:
Figure 3: Interface Manager faceplate
Note: For an explanation of the various LED states, see Troubleshooting.
Table 2: Interface Manager I/O components
Item Description
1
Cascade in back-end Ethernet port (reserved for future functionality)
2
Private Ethernet ports to FC interface controllers
3
Front-end Ethernet port (to LAN)
4
Serial port
5
Auxiliary RJ-11 serial connector (not used)
6
Board status LEDs
7
Reset button
8
Green link speed LED
9
Green link activity LED
1 2 3 54 6
789