HP StorageWorks Interface Manager and Command View TL Installation Guide (March 2005)
Table Of Contents
- Title
- Contents
- About this Guide
- 1: Introduction
- 2: Hardware Installation
- Preparing the Installation
- Installing the Expansion Cage in the ESL Series Library
- Installing the Fibre Channel Interface Controllers into the Expansion Cage
- Installing the Interface Manager Card into the Expansion Cage
- Connecting the Cables
- Connecting the Interface Manager Card to the Fibre Channel Interface Controllers
- Connecting the SCSI Bus Cables
- Connecting the Fibre Channel Cables
- Connecting the Interface Manager Card to the LAN
- Connecting the PC or Laptop
- Completing the Hardware Installation
- 3: Configuration and Software Installation
- 4: Troubleshooting
- A: Serial and Ethernet Pin Assignments
- B: Regulatory Compliance Notice
- Federal Communications Commissions Notice
- Harmonics Conformance (Japan)
- German Noise Declaration
- C: Electrostatic Discharge
- D: Specifications
- Index
Introduction
18 Interface Manager and Command View TL Installation Guide
Prerequisites
Successful operation of the Interface Manager card requires the following:
■ HP StorageWorks ESL9000 Series Tape Library with a minimum firmware
revision of 3.40
■ Interface Manager card and documentation
■ ESL9000 Series library expansion cage and supplied installation hardware
(ships with the Interface Manager card)
■ One to four HP StorageWorks e2400-160 Fibre Channel interface controllers
with a minimum firmware revision of 5.1.08
■ Management station—a Microsoft® Windows®-based PC (server). Ideally,
the management station should be dedicated for use with the Interface
Manager card and have a static IP address.