HP StorageWorks Interface Manager and Command View TL Installation Guide (March 2005)
Table Of Contents
- Title
- Contents
- About this Guide
- 1: Introduction
- 2: Hardware Installation
- Preparing the Installation
- Installing the Expansion Cage in the ESL Series Library
- Installing the Fibre Channel Interface Controllers into the Expansion Cage
- Installing the Interface Manager Card into the Expansion Cage
- Connecting the Cables
- Connecting the Interface Manager Card to the Fibre Channel Interface Controllers
- Connecting the SCSI Bus Cables
- Connecting the Fibre Channel Cables
- Connecting the Interface Manager Card to the LAN
- Connecting the PC or Laptop
- Completing the Hardware Installation
- 3: Configuration and Software Installation
- 4: Troubleshooting
- A: Serial and Ethernet Pin Assignments
- B: Regulatory Compliance Notice
- Federal Communications Commissions Notice
- Harmonics Conformance (Japan)
- German Noise Declaration
- C: Electrostatic Discharge
- D: Specifications
- Index
Hardware Installation
23Interface Manager and Command View TL Installation Guide
The following procedures, Installing the Cooling Fan, Installing the Expansion
Cage, and Installing the Cable Clamp, only apply to first-time installations. If this
is a first time installation, proceed with Installing the Cooling Fan. Otherwise, do
one of the following:
■ If you are installing additional FC interface controllers with the Interface
Manager card, skip to the section, Installing the Fibre Channel Interface
Controllers into the Expansion Cage.
■ If you are installing only the Interface Manager card, skip to the section,
Installing the Interface Manager Card into the Expansion Cage.
Installing the Cooling Fan
The expansion cage requires a cooling fan to provide airflow through the cage.
This fan must be installed into the electronics bay before the cage is installed. To
install the fan:
1. Remove the screws that are attached to the fan and put them in a safe place.
2. Position the fan so that the feet angle downward towards the holes in the side
wall.
3. Position the fan cable against the side wall of the electronics bay and drop it
down through the opening in the floor of the bay.
4. Seat the fan by inserting the feet into the last row of available holes on the
electronics bay wall.