HP StorageWorks Interface Manager and Command View TL Installation Guide (March 2005)
Table Of Contents
- Title
- Contents
- About this Guide
- 1: Introduction
- 2: Hardware Installation
- Preparing the Installation
- Installing the Expansion Cage in the ESL Series Library
- Installing the Fibre Channel Interface Controllers into the Expansion Cage
- Installing the Interface Manager Card into the Expansion Cage
- Connecting the Cables
- Connecting the Interface Manager Card to the Fibre Channel Interface Controllers
- Connecting the SCSI Bus Cables
- Connecting the Fibre Channel Cables
- Connecting the Interface Manager Card to the LAN
- Connecting the PC or Laptop
- Completing the Hardware Installation
- 3: Configuration and Software Installation
- 4: Troubleshooting
- A: Serial and Ethernet Pin Assignments
- B: Regulatory Compliance Notice
- Federal Communications Commissions Notice
- Harmonics Conformance (Japan)
- German Noise Declaration
- C: Electrostatic Discharge
- D: Specifications
- Index
Hardware Installation
25Interface Manager and Command View TL Installation Guide
7. Using a Phillips screwdriver, remove the six screws securing the cover to the
electronics bay. Make sure that you support the bottom of the cover while
removing the screws.
Figure 8: Removing the electronics bay side cover
8. Route the fan cable to the right of any existing cards.
Caution: The area for the fan power cable is limited. Route the cable as far
back on the electronics bay as it will go. This prevents the cable from being
damaged when the expansion cage is installed.
Figure 9: Routing the fan cable