HP StorageWorks Interface Manager and Command View TL Installation Guide (March 2005)
Table Of Contents
- Title
- Contents
- About this Guide
- 1: Introduction
- 2: Hardware Installation
- Preparing the Installation
- Installing the Expansion Cage in the ESL Series Library
- Installing the Fibre Channel Interface Controllers into the Expansion Cage
- Installing the Interface Manager Card into the Expansion Cage
- Connecting the Cables
- Connecting the Interface Manager Card to the Fibre Channel Interface Controllers
- Connecting the SCSI Bus Cables
- Connecting the Fibre Channel Cables
- Connecting the Interface Manager Card to the LAN
- Connecting the PC or Laptop
- Completing the Hardware Installation
- 3: Configuration and Software Installation
- 4: Troubleshooting
- A: Serial and Ethernet Pin Assignments
- B: Regulatory Compliance Notice
- Federal Communications Commissions Notice
- Harmonics Conformance (Japan)
- German Noise Declaration
- C: Electrostatic Discharge
- D: Specifications
- Index
Hardware Installation
27Interface Manager and Command View TL Installation Guide
Figure 11: Expansion cage connector pins
3. Locate the guide pins for alignment. Lower the expansion cage into the
electronics bay into the guide pin holes located on the PCI backplane.
Figure 12: Aligning the guide pins
4. Press down evenly on both sides of the expansion cage until it is firmly seated.
Caution: Be careful not to pinch the fan power cable.
Caution: Make sure that the connectors on the expansion cage and the PCI
backplane align properly.