HP StorageWorks Interface Manager and Command View TL Installation Guide (March 2005)
Table Of Contents
- Title
- Contents
- About this Guide
- 1: Introduction
- 2: Hardware Installation
- Preparing the Installation
- Installing the Expansion Cage in the ESL Series Library
- Installing the Fibre Channel Interface Controllers into the Expansion Cage
- Installing the Interface Manager Card into the Expansion Cage
- Connecting the Cables
- Connecting the Interface Manager Card to the Fibre Channel Interface Controllers
- Connecting the SCSI Bus Cables
- Connecting the Fibre Channel Cables
- Connecting the Interface Manager Card to the LAN
- Connecting the PC or Laptop
- Completing the Hardware Installation
- 3: Configuration and Software Installation
- 4: Troubleshooting
- A: Serial and Ethernet Pin Assignments
- B: Regulatory Compliance Notice
- Federal Communications Commissions Notice
- Harmonics Conformance (Japan)
- German Noise Declaration
- C: Electrostatic Discharge
- D: Specifications
- Index
Hardware Installation
30 Interface Manager and Command View TL Installation Guide
Completing the Installation
1. Use a multimeter to measure the resistance shown on the PCI backplane.
Place one lead on ground and the other lead on the +3.3V, +5V, and +12V test
points to be checked. If the multimeter shows a short, check the expansion
cage and fan to ensure proper connections.
Figure 16: Checking the resistance on the PCI back plane
2. Reinstall the electronics bay cover using the top three screws only. Install the
lower cable clamp on the electronics bay cover using the bottom three screws.
Figure 17: Installing the electronics bay cover and lower cable clamp