HP StorageWorks Interface Manager and Command View TL Installation Guide (March 2005)
Table Of Contents
- Title
- Contents
- About this Guide
- 1: Introduction
- 2: Hardware Installation
- Preparing the Installation
- Installing the Expansion Cage in the ESL Series Library
- Installing the Fibre Channel Interface Controllers into the Expansion Cage
- Installing the Interface Manager Card into the Expansion Cage
- Connecting the Cables
- Connecting the Interface Manager Card to the Fibre Channel Interface Controllers
- Connecting the SCSI Bus Cables
- Connecting the Fibre Channel Cables
- Connecting the Interface Manager Card to the LAN
- Connecting the PC or Laptop
- Completing the Hardware Installation
- 3: Configuration and Software Installation
- 4: Troubleshooting
- A: Serial and Ethernet Pin Assignments
- B: Regulatory Compliance Notice
- Federal Communications Commissions Notice
- Harmonics Conformance (Japan)
- German Noise Declaration
- C: Electrostatic Discharge
- D: Specifications
- Index
Hardware Installation
32 Interface Manager and Command View TL Installation Guide
Installing the Fibre Channel Interface Controllers
1. Push the ejector handles so that they extend towards the outer edges of the FC
interface controller.
Figure 18: e2400-160 Interface Controller ejector handles
2. With the SCSI ports located to your left as you face the back of the library,
align the sides of the controller with the guides in the designated slot in the
expansion cage.
3. Gently push the controller into the expansion cage slot, ensuring that the
alignment pin on the controller aligns with the alignment hole in the
corresponding cage slot. Push the controller until the ejector handles engage
the metal rails on the top of the cage.