HP StorageWorks Interface Manager and Command View TL Installation Guide (March 2005)
Table Of Contents
- Title
- Contents
- About this Guide
- 1: Introduction
- 2: Hardware Installation
- Preparing the Installation
- Installing the Expansion Cage in the ESL Series Library
- Installing the Fibre Channel Interface Controllers into the Expansion Cage
- Installing the Interface Manager Card into the Expansion Cage
- Connecting the Cables
- Connecting the Interface Manager Card to the Fibre Channel Interface Controllers
- Connecting the SCSI Bus Cables
- Connecting the Fibre Channel Cables
- Connecting the Interface Manager Card to the LAN
- Connecting the PC or Laptop
- Completing the Hardware Installation
- 3: Configuration and Software Installation
- 4: Troubleshooting
- A: Serial and Ethernet Pin Assignments
- B: Regulatory Compliance Notice
- Federal Communications Commissions Notice
- Harmonics Conformance (Japan)
- German Noise Declaration
- C: Electrostatic Discharge
- D: Specifications
- Index
Hardware Installation
34 Interface Manager and Command View TL Installation Guide
5. Repeat step 1 through step 4 for each controller to be installed.
6. Install 6U filler panels (slot covers) into any unused slots.
Caution: Failure to install filler panels in unused slots may result in thermal
damage to the hardware.
Figure 21: Installing filler panels in unused slots
7. Tighten the captive screws to secure the e2400-160 FC Interface Controllers
into the expansion cage.
Figure 22: Securing the interface controllers to the cage