HP StorageWorks Interface Manager and Command View TL Installation Guide (March 2005)
Table Of Contents
- Title
- Contents
- About this Guide
- 1: Introduction
- 2: Hardware Installation
- Preparing the Installation
- Installing the Expansion Cage in the ESL Series Library
- Installing the Fibre Channel Interface Controllers into the Expansion Cage
- Installing the Interface Manager Card into the Expansion Cage
- Connecting the Cables
- Connecting the Interface Manager Card to the Fibre Channel Interface Controllers
- Connecting the SCSI Bus Cables
- Connecting the Fibre Channel Cables
- Connecting the Interface Manager Card to the LAN
- Connecting the PC or Laptop
- Completing the Hardware Installation
- 3: Configuration and Software Installation
- 4: Troubleshooting
- A: Serial and Ethernet Pin Assignments
- B: Regulatory Compliance Notice
- Federal Communications Commissions Notice
- Harmonics Conformance (Japan)
- German Noise Declaration
- C: Electrostatic Discharge
- D: Specifications
- Index
Hardware Installation
36 Interface Manager and Command View TL Installation Guide
Installing the Interface Manager Card
1. Push the ejector handles so that they extend towards the outer edges of the
Interface Manager card.
Figure 23: Interface Manager card ejector handles
2. Align the sides of the Interface Manager card with the guides in either one of
the 4U slots in the expansion cage as shown in Figure 24.
3. Gently push the Interface Manager card into the expansion cage slot, making
sure that the alignment pin on the card aligns with the alignment hole in the
corresponding cage slot. Push the card until the ejector handles engage the
metal rails on the top of the cage.
Note: If this is an upgrade installation, you will need to remove a 4U filler panel before
installing the Interface Manager card.