HP StorageWorks Interface Manager and Command View TL Installation Guide (March 2005)
Table Of Contents
- Title
- Contents
- About this Guide
- 1: Introduction
- 2: Hardware Installation
- Preparing the Installation
- Installing the Expansion Cage in the ESL Series Library
- Installing the Fibre Channel Interface Controllers into the Expansion Cage
- Installing the Interface Manager Card into the Expansion Cage
- Connecting the Cables
- Connecting the Interface Manager Card to the Fibre Channel Interface Controllers
- Connecting the SCSI Bus Cables
- Connecting the Fibre Channel Cables
- Connecting the Interface Manager Card to the LAN
- Connecting the PC or Laptop
- Completing the Hardware Installation
- 3: Configuration and Software Installation
- 4: Troubleshooting
- A: Serial and Ethernet Pin Assignments
- B: Regulatory Compliance Notice
- Federal Communications Commissions Notice
- Harmonics Conformance (Japan)
- German Noise Declaration
- C: Electrostatic Discharge
- D: Specifications
- Index
Hardware Installation
41Interface Manager and Command View TL Installation Guide
Connecting the SCSI Bus Cables
1. Connect the SCSI connectors on the FC interface controllers to the SCSI
connectors on the library SCSI bulkhead. See ESL9322 SCSI Cable
Configurations or ESL9595 SCSI Cable Configurations for detailed SCSI
cabling instructions.
2. Secure the SCSI cables going from the controller to the library bulkhead by
snapping them into the clips in the upper and lower cable clamps located on
the electronics enclosure, as shown in Figure 29. To prevent interference with
the door, do not use the fourth and fifth clips from the right edge of the cable
clamp.
Figure 29: Securing the SCSI cables