HP StorageWorks Interface Manager and Command View TL Installation Guide (March 2005)
Table Of Contents
- Title
- Contents
- About this Guide
- 1: Introduction
- 2: Hardware Installation
- Preparing the Installation
- Installing the Expansion Cage in the ESL Series Library
- Installing the Fibre Channel Interface Controllers into the Expansion Cage
- Installing the Interface Manager Card into the Expansion Cage
- Connecting the Cables
- Connecting the Interface Manager Card to the Fibre Channel Interface Controllers
- Connecting the SCSI Bus Cables
- Connecting the Fibre Channel Cables
- Connecting the Interface Manager Card to the LAN
- Connecting the PC or Laptop
- Completing the Hardware Installation
- 3: Configuration and Software Installation
- 4: Troubleshooting
- A: Serial and Ethernet Pin Assignments
- B: Regulatory Compliance Notice
- Federal Communications Commissions Notice
- Harmonics Conformance (Japan)
- German Noise Declaration
- C: Electrostatic Discharge
- D: Specifications
- Index
Hardware Installation
42 Interface Manager and Command View TL Installation Guide
ESL9322 SCSI Cable Configurations
Figure 30 shows the SCSI ports as viewed from the rear of the ESL9322 tape
library.
Figure 30: SCSI ports (ESL9322)
Looking from the rear of the ESL9322 tape library, connect the SCSI cables and
terminators as shown in Figure 31.
Note: ESL9322 Series libraries are equipped with internal SCSI cables and terminators
in place for a one drive per SCSI bus configuration. This is the recommended
configuration (and the required configuration for Ultrium 460 drives) and ensures
optimal performance.
Figure 31 shows the internal SCSI cabling. The connectors are on the SCSI ports
that are shown in Figure 30.
Note: Drive numbering begins with 0. Consequently, the first drive is drive 0, the
second drive is drive 1, and so on.
DIAG.
D
E
F
G
DRIVE POSITION
H
I
J
B
C
CONT.
K
L
PTM
A
1
2
3
4
5
6
7
9
0
8
EXPANSION
DRIVES