HP StorageWorks Interface Manager and Command View TL Installation Guide (March 2005)
Table Of Contents
- Title
- Contents
- About this Guide
- 1: Introduction
- 2: Hardware Installation
- Preparing the Installation
- Installing the Expansion Cage in the ESL Series Library
- Installing the Fibre Channel Interface Controllers into the Expansion Cage
- Installing the Interface Manager Card into the Expansion Cage
- Connecting the Cables
- Connecting the Interface Manager Card to the Fibre Channel Interface Controllers
- Connecting the SCSI Bus Cables
- Connecting the Fibre Channel Cables
- Connecting the Interface Manager Card to the LAN
- Connecting the PC or Laptop
- Completing the Hardware Installation
- 3: Configuration and Software Installation
- 4: Troubleshooting
- A: Serial and Ethernet Pin Assignments
- B: Regulatory Compliance Notice
- Federal Communications Commissions Notice
- Harmonics Conformance (Japan)
- German Noise Declaration
- C: Electrostatic Discharge
- D: Specifications
- Index
Hardware Installation
43Interface Manager and Command View TL Installation Guide
Figure 31: Internal SCSI cabling configuration (ESL9322)
Table 3: SCSI Ports and Device Connections (ESL9322)
SCSI Port Identifier Device Connection
ADrive 0
BDrive 1
CDrive 2
DDrive 3
EDrive 4
FDrive 5
GDrive 6
HDrive 7
INot used
JNot used
K Robot
LHost
E
SCSI
A
SCSI
SCSI
I
L
J
K
SCSI
SCSI SCSI
C
SCSI
B
SCSI
D
SCSI
G
SCSI
F
SCSI
H
SCSI
Drive # 0
SCSI ID 1
Drive # 1
SCSI ID 2
Drive # 2
SCSI ID 3
Drive # 3
SCSI ID 4
Drive # 4
SCSI ID 1
Drive # 5
SCSI ID 2
Drive # 6
SCSI ID 3
Drive # 7
SCSI ID 4
1
4
3
1
1
1
2
2
2
2
2
2
2
2
1
1
1
1
5
1
2
Terminators
SCSI cables
3
4
Drive Column 1
Robotic Controller
5 Host SCSI Cable