HP StorageWorks Interface Manager and Command View TL Installation Guide (March 2005)
Table Of Contents
- Title
- Contents
- About this Guide
- 1: Introduction
- 2: Hardware Installation
- Preparing the Installation
- Installing the Expansion Cage in the ESL Series Library
- Installing the Fibre Channel Interface Controllers into the Expansion Cage
- Installing the Interface Manager Card into the Expansion Cage
- Connecting the Cables
- Connecting the Interface Manager Card to the Fibre Channel Interface Controllers
- Connecting the SCSI Bus Cables
- Connecting the Fibre Channel Cables
- Connecting the Interface Manager Card to the LAN
- Connecting the PC or Laptop
- Completing the Hardware Installation
- 3: Configuration and Software Installation
- 4: Troubleshooting
- A: Serial and Ethernet Pin Assignments
- B: Regulatory Compliance Notice
- Federal Communications Commissions Notice
- Harmonics Conformance (Japan)
- German Noise Declaration
- C: Electrostatic Discharge
- D: Specifications
- Index
Hardware Installation
45Interface Manager and Command View TL Installation Guide
Figure 33: Internal SCSI cabling configuration (ESL9595)
1 SCSI cables (8) 3 Robotic controller 5 Drive column 2
2 Terminators (8) 4 Drive column 1 6 Host SCSI Cable
Drive # 8
Drive # 9
Drive # 10
Drive # 11
Drive # 12
Drive # 13
Drive # 14
Drive # 15
Drive # 0
Drive # 1
Drive # 2
Drive# 3
Drive # 4
Drive # 5
Drive # 6
Drive # 7
A B C D E F G HP
Q
O N M L K J I
4
3
5
1
2
1
2
1
2
2
1
2
1
2
1
2
1
2
1
R
1
2
1
2
1
2
2
1
2
1
2
1
2
1
2
1
6
1