HP StorageWorks Interface Manager and Command View TL Installation Guide (March 2005)
Table Of Contents
- Title
- Contents
- About this Guide
- 1: Introduction
- 2: Hardware Installation
- Preparing the Installation
- Installing the Expansion Cage in the ESL Series Library
- Installing the Fibre Channel Interface Controllers into the Expansion Cage
- Installing the Interface Manager Card into the Expansion Cage
- Connecting the Cables
- Connecting the Interface Manager Card to the Fibre Channel Interface Controllers
- Connecting the SCSI Bus Cables
- Connecting the Fibre Channel Cables
- Connecting the Interface Manager Card to the LAN
- Connecting the PC or Laptop
- Completing the Hardware Installation
- 3: Configuration and Software Installation
- 4: Troubleshooting
- A: Serial and Ethernet Pin Assignments
- B: Regulatory Compliance Notice
- Federal Communications Commissions Notice
- Harmonics Conformance (Japan)
- German Noise Declaration
- C: Electrostatic Discharge
- D: Specifications
- Index
Hardware Installation
49Interface Manager and Command View TL Installation Guide
Telnet Method
Connect a standard RJ-45 Ethernet cable from the network port of the PC or
laptop to the cascade port of the Interface Manager card. Route the cable through
the access port on the back of the library.
Figure 36: Connecting to the cascade port
Serial Method
1. Connect the small end of the included serial cable to the 3-pin serial connector
on the Interface Manager card. The connector is keyed so that the cable can
only be installed in the correct orientation. Route the cable through the access
port on the back of the library.
2. Connect the other end of the serial cable to an available serial port on the PC
or laptop.
Figure 37: Connecting to the serial port
CASCADE TO FIBRE CHANNEL CONTROLLERS NETWORK SERIAL AUX STATUS
ERROR
CASCADE
CASCADE TO FIBRE CHANNEL CONTROLLERS NETWORK SERIAL AUX STATUS
ERROR
TWORK SERIAL AUX