HP StorageWorks Interface Manager and Command View TL Installation Guide (March 2005)

Configuration and Software Installation
59Interface Manager and Command View TL Installation Guide
Using Command View TL
Command View TL is installed on the management station and communicates
with the Interface Manager card through the LAN. The management station
processes information from the Interface Manager card and “serves up” the
Command View TL GUI. Users can access Command View TL, either from the
management station directly or through any client on the LAN, by using a
browser-based GUI interface.
This section explains how to install and configure Command View TL for first
time use. For more detailed information on using Command View TL, refer to the
HP StorageWorks Interface Manager and Command View TL User Guide.
Prerequisites
For servers, Command View TL requires a management station (server) with a
minimum of:
■ Pentium IV 1.6-GHz, 512-MB RAM
■ 10/100 Base-T network card (a static IP address is recommended)
■ Microsoft® Windows® 2000 Professional or Server edition SP3, Windows
XP Professional
For clients, Command View TL requires the following:
■ Microsoft Internet Explorer v6.0 SP1 or later, or Netscape Navigator v6.2 or
later. Make sure that Java support is enabled in the browser.
■ An Internet connection is recommended so that Command View TL can
receive firmware and software release information automatically from the HP
Support web site.