HP StorageWorks Interface Manager and Command View TL Installation Guide (March 2005)
Table Of Contents
- Title
- Contents
- About this Guide
- 1: Introduction
- 2: Hardware Installation
- Preparing the Installation
- Installing the Expansion Cage in the ESL Series Library
- Installing the Fibre Channel Interface Controllers into the Expansion Cage
- Installing the Interface Manager Card into the Expansion Cage
- Connecting the Cables
- Connecting the Interface Manager Card to the Fibre Channel Interface Controllers
- Connecting the SCSI Bus Cables
- Connecting the Fibre Channel Cables
- Connecting the Interface Manager Card to the LAN
- Connecting the PC or Laptop
- Completing the Hardware Installation
- 3: Configuration and Software Installation
- 4: Troubleshooting
- A: Serial and Ethernet Pin Assignments
- B: Regulatory Compliance Notice
- Federal Communications Commissions Notice
- Harmonics Conformance (Japan)
- German Noise Declaration
- C: Electrostatic Discharge
- D: Specifications
- Index
Troubleshooting
64 Interface Manager and Command View TL Installation Guide
Off Blinks 2x
per 5
second
interval
Application software is initializing.
Off Blinks 3x
per 5
second
interval
Application is identifying all library components.
Off On Normal state. Application has identified all library
components.
Table 6: Network Link Activity/Speed LEDs
LED Status Description
Link Activity LED
(left side of each
Ethernet port)
Off Port disconnected / no link
On Port connected to another Ethernet device
Flashing Data is being transmitted / received
Link Speed LED
(right side of each
Ethernet port)
On Port is operating at 100 Mbps
Off Port is operating at 10 Mbps, or port is not
connected (see Link Activity LED)
Table 5: Status LED diagnostic codes
Red LED Green LED Description