HP StorageWorks Interface Manager and Command View TL Installation Guide (March 2005)
Table Of Contents
- Title
- Contents
- About this Guide
- 1: Introduction
- 2: Hardware Installation
- Preparing the Installation
- Installing the Expansion Cage in the ESL Series Library
- Installing the Fibre Channel Interface Controllers into the Expansion Cage
- Installing the Interface Manager Card into the Expansion Cage
- Connecting the Cables
- Connecting the Interface Manager Card to the Fibre Channel Interface Controllers
- Connecting the SCSI Bus Cables
- Connecting the Fibre Channel Cables
- Connecting the Interface Manager Card to the LAN
- Connecting the PC or Laptop
- Completing the Hardware Installation
- 3: Configuration and Software Installation
- 4: Troubleshooting
- A: Serial and Ethernet Pin Assignments
- B: Regulatory Compliance Notice
- Federal Communications Commissions Notice
- Harmonics Conformance (Japan)
- German Noise Declaration
- C: Electrostatic Discharge
- D: Specifications
- Index
Interface Manager and Command View TL Installation Guide
Figures
1 High-level architecture. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
2 Multiple libraries connected to a single management station . . . . . . . . . . . . . . . . . . . . . 16
3 Interface Manager faceplate. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
4 Accessing the electronics bay . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22
5 Removing the electronics bay cover . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22
6 Seating the cooling fan. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24
7 Mounting the cooling fan to the electronics bay . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24
8 Removing the electronics bay side cover. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25
9 Routing the fan cable . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25
10 Plugging the fan power cable into the backplane. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26
11 Expansion cage connector pins . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27
12 Aligning the guide pins . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27
13 Securing the expansion cage into the electronics bay . . . . . . . . . . . . . . . . . . . . . . . . . . . 28
14 Installing the cable clips into the cable clamp . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29
15 Installing the upper cable clamp . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29
16 Checking the resistance on the PCI back plane . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30
17 Installing the electronics bay cover and lower cable clamp. . . . . . . . . . . . . . . . . . . . . . . 30
18 e2400-160 Interface Controller ejector handles. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32
19 Inserting the controller. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 33
20 Locking the controller in place . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 33
21 Installing filler panels in unused slots . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34
22 Securing the interface controllers to the cage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34
23 Interface Manager card ejector handles . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36
24 Inserting the Interface Manager card . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37
25 Locking the Interface Manager card in place. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37
26 Securing the Interface Manager card to the cage. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 38
27 Connecting the Ethernet cable bundle to the Interface Manager card . . . . . . . . . . . . . . . 39
28 Connecting the Interface Manager card to the FC interface controllers . . . . . . . . . . . . . 40
29 Securing the SCSI cables . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 41
30 SCSI ports (ESL9322) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 42
31 Internal SCSI cabling configuration (ESL9322) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43
32 SCSI ports (ESL9595) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44
33 Internal SCSI cabling configuration (ESL9595) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45
34 Cable access port . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 47
35 Connecting the Interface Manager card to the LAN . . . . . . . . . . . . . . . . . . . . . . . . . . . . 48
36 Connecting to the cascade port . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 49
37 Connecting to the serial port . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 49