HP StorageWorks ESL Power Supply Replacement Guide (March 2003)

Slowly swing
the top of the
power supply
rack out of the
cabinet until it
rests against
the rack stops.
56
Using a flat-blade screwdriver, loosen the two
captive screws that secure the power supply in
the rack.
78
Pull on the handle to remove the power supply
from the rack.
Install the new power supply by sliding it into the
empty slot.
910
Using a flat-blade screwdriver, tighten the two
captive screws on the top of the new power
supply to secure it to the rack.
FAULT OUTPUT
GOOD
replacement
Determine which power supply you need to
replace, and turn off its power switch.
Note: The “FAULT” LED should be
illuminated on the faulty power supply.