HP Z440 Workstation QuickSpecs
Expansion Slots
(see
system board section for
more details)
Slot 1
(top):
PCI Express Gen2 x1 with open-ended connector*
Full-height, Half-length
Slot 2
:
PCI Express Gen3 x16
Full-height, Full-length (with extender)
Slot 3
:
PCI Express Gen2 x4 with open-ended connector*
Full-height, Full-length (with extender)
Slot 4
:
PCI Express Gen3 x8 with open-ended connector*
Full-height, Full-length (with extender)
Slot 5
:
PCI Express Gen3 x16
Full-height, Full-length (with extender)
Slot 6:
PCI 32bit/33MHz
Full-height, Full-length (with extender)
* Open-ended connector allows a greater bandwidth (e.g. x16) card to be installed physically into a lower
bandwidth connector/slot.
Expansion Bays (see
storage section for more
details)
2 internal 3.5" bays (with acoustic dampening rail assemblies pre-installed)
2 external 5.25" bays
3rd and 4th 3.5" HDD each occupy one external bay
3rd and 4th 2.5" HDD/SSD occupy a single external bay within a 2:1 carrier)
1 dedicated 9.5mm slim optical disk drive bay
Front I/O
4 USB 3.0, 1 Headset, 1 Microphone
Internal I/O
1 USB 2.0 ports available by a 2x5 header. Each 2x5 header supports either one HP Internal USB Port Kit
(EM165AA) or one 15-in-1 Media Card Reader.
1 USB 3.0 port available by a 2x10 header.
Rear I/O
4 USB 3.0, 2 USB 2.0, 2 PS/2, 1 RJ-45 (NIC), 1 Audio Line-In, 1 Audio Line-Out.
Serial supported with optional connector on PCI bracket cabled to system board connector.
Interfaces Supported
15-in-1 Media Card Reader (optional)
6-channel SATA interface (6 @ 6.0 Gb/s). 6 channels are eSATA configurable for use with eSATA CTO/AMO
Kit (No hot plug / hot swap supported).
USB 2.0, USB 3.0
On-board RAID Support
RAID 0, 1, 10
Chassis Dimensions
(HxWxD)
43.2 x 16.9 x 44.5 cm
17.0 x 6.65 x 17.5 in
Rack Dimensions
4U
Weight
Exact weights depend upon configuration.
Minimum: 11.0 kg (24.3 lbs.)
Standard: 13.5 kg (29.8 lbs.)
Maximum: 17.5 kg (38.5 lbs.)
QuickSpecs
HP Z440 Workstation
Overview
DA - 15077 Worldwide QuickSpecs — Version 2 — 10/1/2014
Page 4