HP LaserJet Enterprise MFP M527 and M506 - Formatter Install Guide











18 19

20 21

Rotate the bottom edge of the DIMM toward the holder

(callout 1), and then make sure that the two locking arms snap

into place (callout 2).

NOTE: M506 printers and M527dn models only. For all other

models, skip this step and go to Step 20.

Align the connector on the replacement eMMC (callout 1) with the

connector on the formatter, and then push the eMMC onto the

formatter to install it.

NOTE: The eMMC is keyed and can only be installed in one direc-

tion on the formatter.

Insert the HDD cradle mounting tab in the slot in the sheet-metal

(callout 1), and then rotate the connector end (callout 2) of the

HDD toward the formatter.

NOTE: HDD models only. For all other models, skip this step and

go to Step 23.

Before proceeding, take note of the location of the slot

(callout 1) in the sheet-metal where the HDD cradle mounting

tab (callout 2) must be installed.

CAUTION: This portion of the sheet-metal is a knock-out plate

(callout 1). Do not push on it with sufficient force to detach it

when installing the HDD.