Installation Manual

11
Attaching the Adapter to Other Fibre Channel Devices
To attach the adapter to other Fibre Channel devices, follow these steps:
1. Remove the Fibre Channel host bus adapter’s optical port protector (if included).
2. Attach a connector cable to the Fibre Channel host bus adapter.
a. Align the slotted plug with the keyed connector.
b. Push the connector in until you hear it click.
3. Attach the free end of the cable to a compatible Fibre Channel device.
4. Reconnect the power cord, if necessary, and power on the system.
Table 1-1 lists the Fibre Channel cables that you can use when connecting devices to Fibre Channel host bus
adapters.
Verifying Installation
1. To verify the adapter installation, enter the command:
ioscan -f
2. Verify that the following drivers appear for each installed adapter. If all drivers display, proceed to the
next section,
Verifying Connectivity.
Table 1-1 Cable Products
LC-LC
221692-B21 Fibre Optic Cable 2m LC/LC Duplex 50/125 M/M
221692-B23 Fibre Optic Cable 15m LC/LC Duplex 50/125 M/M
221692-B26 Fibre Optic Cable 30m LC/LC Duplex 50/125 M/M
221692-B27 Fibre Optic Cable 50m LC/LC Duplex 50/125 M/M
LC-SC
221691-B21 Fibre Optic Cable 2m LC/SC Duplex 50/125 M/M Optical
221691-B23 Fibre Optic Cable 15m LC/SC Duplex 50/125 M/M Optical