HP Workstations - Front fan and fan holder installation

5. Lower the front fan holder and fan assembly into the chassis and snap it into place. Ensure cables
are routed properly to avoid damage to the cables.
CAUTION: Clamping a cable between the card guide and the chassis might damage the cable.
Figure 1 Routing the cables
6. Plug the front fan connector into the front chassis fan header on the system board.
NOTE: To locate system board components, see the service label on the side access panel.
Table 2 Installing the front fan and fan holder
HP xw4000 Workstation series
HP 400 Workstations
HP xw6000 Workstation series HP xw9300 Workstations
4 Front fan and fan holder installation ENWW