HP ProBook 640 G1, 645 G1, 650 G1, and 655 G1 Notebook PCs - Maintenance and Service Guide
Table Of Contents
- Product description
- External component identification
- Illustrated parts catalog
- Removal and replacement procedures preliminary requirements
- Removal and replacement procedures for Customer Self-Repair parts
- Removal and replacement procedures for Authorized Service Provider parts
- Computer Setup (BIOS), TPM, and HP Sure Start – Windows 10
- Using HP PC Hardware Diagnostics (UEFI) – Windows 10
- Computer Setup
- Windows 8 — Computer Setup (BIOS), MultiBoot, and System Diagnostics
- Windows 7 — Computer Setup (BIOS), MultiBoot, and HP PC Hardware Diagnostics (UEFI)
- Specifications
- Backup and recovery – Windows 10
- Backup and recovery
- Statement of Volatility
- Power cord set requirements
- Recycling
- Index
●
Function button board (see Function button board on page 96)
●
Power button board (see Power button board on page 86)
●
Fingerprint reader board (see Fingerprint reader board on page 87)
Remove the TouchPad:
1. Remove the four Torx screws (1) that secure the TouchPad to the top cover.
2. Release the clip (2), and then remove the TouchPad (3).
Reverse this procedure to install the TouchPad.
Power connector cable
Description Spare part number
For use on models equipped with a 15.6-in. display assembly 738694-001
For use on models equipped with a 14-in. display assembly 738683-001
Before removing the power connector cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see Battery on page 56), and then remove the following components:
Power connector cable 101