Setting up and configuring Intel AMT in HP Business Notebooks, Desktops, and Workstations - Technical white paper

Configuring IPv4

Select Wired LAN IPV4 Configuration and then configure the parameters shown in Figure 12.

Figure 12. Configuring the network for IPv4

– DHCP Mode: Enabled (Recommended setting; default)

If DHCP is enabled (recommended), skip to Step 16.

If DHCP is disabled, complete steps (i) – (v) of Implementing wireless connectivity for Intel AMT to configure an IPv4

static IP address for Intel AMT.

– IPV4 Address: (Network-dependent; default is 0.0.0.0 )

Specify the desired static IP address (such as 192.168.0.1). Ensure that each Intel AMT system has a unique IP

address. Multiple systems sharing the same IP address may result in network collisions that would cause the

systems to respond incorrectly.

– Subnet Mask Address: (Network-dependent; default is 255.255.255.0)

– Default Gateway Address: (Network-dependent; default is 0.0.0.0)

– Preferred DNS Address: (Network-dependent; default is 0.0.0.0)

– Alternate DNS Address: (Network-dependent; default is 0.0.0.0)