Setting up and configuring Intel AMT in HP Business Notebooks, Desktops, and Workstations - Technical white paper

Configuring IPv6
Both wired and wireless
6
IPv6 can be enabled via an SCS or, as in this example, the WebUI.
Review the TCP/IPv6 settings for wired and wireless connections, as shown in Figure 13:
– Enable IPv6 (wired): Enabled (Recommended setting; default setting is Disabled)
– Enable IPv6 (wireless): (Implementation-dependent; default setting is Disabled)
Figure 13. Configuring wired and wireless networks for IPv6 via the WebUI
Implementing wireless connectivity for Intel AMT
Consider the following caveats:
– For desktop PCs, wireless Intel AMT is supported on EliteDesk 800 G1 Ultra Slim, Small Form Factor, and Microtower
systems, and EliteOne 800 G1 All-in-One systems using the Intel Centrino Advanced-N 6205 mini PCI wireless LAN card
or the add-on PCI Express x1 option card with Intel Centrino Advanced-N 6205.
– For business notebook PCs, wireless Intel AMT is supported on Intel Centrino Advanced-N 6205/6235 and Intel Dual
Band Wireless-N 7260 802.11 adapters, and Intel Dual Band Wireless-AC 7260 802.11a/b/g/n/ac adapters; wired Intel
AMT is supported on Integrated Intel 1217LM and 1218LM Gigabit Network Connection.
– Intel AMT only supports DHCP and does not support static IP addresses.
– Wired and wireless Intel AMT traffic cannot travel on the same subnet concurrently.
6
Wireless Intel AMT support is not provided on HP Workstation PCs.
17