Computer Setup (F10) Utility Guide - dx2300 MT

Computer Setup—Boot
NOTE: Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table 5 Computer Setup—Boot
Option Description
Device Boot Disabling Allows disabling of bootable device groups. Choose from:
●
None
●
USB
●
Internal ODD
●
Internal FDD
●
USB+ODD+FDD
F9 Boot Menu Disables/enables F9 Boot Menu.
Removable Device
Boot Seq.
Allows you to specify the order of attached removable devices (such as Floppy Discs or USB FDD).
The first drive in the order has priority in the boot sequence and is recognized as drive A.
Hard Disk Boot Priority Allows you to specify the order of attached hard drive devices (such as USB HDD storage, USB2
Drive Key, or USB flash media). The first drive in the order has priority in the boot sequence and is
recognized as drive C (if any devices are attached).
Optical Drive Boot
Seq.
Allows you to specify the order in which attached optical drives (including USB ODD) are checked
for a bootable operating system image.
Network Boot Priority Allows you to specify the order in which network devices (including UP NIC cards) are checked for
a bootable operating system image.
First Boot Device
Second Boot Device
Third Boot Device
Fourth Boot Device
Allows you to specify which devices will boot first, second, third, and fourth or to disable any of the
four:
●
Removable
●
Hard Disk
●
CDROM
●
Network
●
Disabled
NOTE: MS-DOS drive lettering assignments may not apply after a non-MS-DOS operating
system has started.
Set Supervisor
Password
Allows you to establish a password to control access to Computer Setup.
Set User Password Allows you to establish a password to control access to the computer. (Supervisor password must
be set before you can set a User password.)
Security Option Allows you to set the security option to Setup or System so that the password is required every time
the system boots or only when entering Computer Setup.
ENWW Computer Setup (F10) Utilities 7