HP Compaq dx2300 and dx2308 Business PC Service Reference Guide, 1st Edition

Speaker
1.
Prepare the computer for disassembly (
Preparation for Disassembly on page 37)
2.
Remove the access panel (
Access Panel on page 38)
3.
Remove the front bezel (
Front Bezel on page 39)
4.
Disconnect the speaker cable from the system board.
5.
Free the cable from the cable tie that is attached to the chassis.
6.
Remove the screw that secures the speaker to the inside of the chassis (1) then, remove the speaker
(2) by sliding it out of the retaining clips..
To install the speaker, reverse the removal procedure.
When installing the speaker, make sure the speaker wires point towards the speaker retaining screw.
56 Chapter 7 Removal and Replacement Procedures— Microtower (MT) Chassis ENWW