Programming Reference Guide

Reading Parameters Enter/Exit Programming Mode

Mobile Bias

This variable mode alters scan module operation, optimizing barcode scanning for reading

from mobile device displays rather than standard labels. The range for this setting is from 0

to 255.

Illumination Off Time

This feature defines the amount of time illumination is kept OFF after Illumination ON

timeout. When illumination OFF expires, Object Sense is resumed. This configuration is

available in Automatic (Object Sense) only. Range is 0 millisecond to 25.5 milliseconds in

100 millisecond intervals.

No Mobile Bias

Set Mobile Bias

To configure, scan the ENTER/EXIT PROGRAM-

MING MODE barcode above, then the barcode at

left followed

by the digits from the Alphanumeric

characters in Appendix D, Keypad representing

your desired character(s). End by scanning the

ENTER/E

XIT barcode.

Make a mistake? Scan the CANCEL barcode to

abort and not save the entry s

tring. You can then start

again at the beginning.

CANCEL

DEFAULT

$CSILF00\r

$CSILF

Select Illumination Off Time Setting

To configure this feature, scan the ENTER/EXIT

PROGRAMMING MODE barcode above, then the

barcode at left followed by the digits from the

Alphanumeric characters in Appendix D, Keypad

representing your desired character(s). End by scan-

ning the ENTER/EXIT barcode again.

$CSNOO

DEFAULT

0 milliseconds