Programming Reference Guide

References

232 HP Wireless Barcode Scanner

Scanning Active Time

This setting specifies the amount of time that the scanner stays in scan ON state once the

state is entered. The range for this setting is from 1 to 255 seconds in 1-second increments.

Follow these instructions to set this feature:

1. Determine the desired setting.

2. Pad the result with leading zeroes to yield three

digits. For example: 0 = 000, 5 = 005,

20 = 020, etc.

3. Go to page 57 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter

Programming Mode.

4. Scan the barcode: SELECT SCANNING ACTIVE TIME SETTING.

5. Scan the appropriate three dig

its from the keypad in Appendix D, Keypad, that repre-

sent the duration which was determined in the

steps above. You will hear a two-beep

indication after the last character.

6. Scan the ENTER/EXIT PROGRAMMING MODE barcod

e to exit Programming

Mode.

This completes the procedure. See Table 38 for some examples of how to set this feature.

Table 38. Scanning Active Time Setting Examples

If you make a mistake before the last character, scan the CANCEL barcode to

abort and not save the entry string. You can then start again at the begin-

ning.

STEP ACTION EXAMPLES

1 Desired Setting

1 Second 90 Sec. (1.5 min.) 180 Sec. (3 min.) 255 Seconds (4.25 min.)

2 Pad leading zero(es)

001 090 180 255

3 Scan ENTER/EXIT PROGRAMMING MODE

4 Scan SELECT SCANNING ACTIVE TIME SETTING

Scan Three Characters From

Appendix D, Keypad

‘0’, ‘0’ and ‘1’ ‘0’, ‘9’ and ‘0’ ‘1’, ‘8’ and ‘0’ ‘2’, ‘5’ and ‘5’

6 Scan ENTER/EXIT PROGRAMMING MODE