Programming Reference Guide

Enter/Exit Programming Mode
Programming Reference Guide 59
Flash On Time
This feature specifies the ON time for the indicator LED while in Flash Mode. The
selectable range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100 millisecond
increments. See page 234 in “References” for detailed informat
ion on setting this feature.
Flash Off Time
This feature specifies the OFF time for the indicator LED while in Flash Mode. The
selectable range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100 millisecond
increments. See page 235 in “References” for detailed informat
ion on setting this feature.
DEFAULT
14 = Motion Still Timeout for 2 seconds
Select Flash ON Time Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE barcode above, then the barcode at
l
eft followed by the digits from the Alphanumeric char-
acters in
Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/EXIT
ba
rcode again.
Make a mistake? Scan the CANCEL barcode to abort and
not
save the entry string. You can then start again at the
beginning.
CANCEL
$CSNFN
~
DEFAULT
10 = Flash is ON for 1 Second
Select Flash OFF Time Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE barcode above, then the barcode at
l
eft followed by the digits from the Alphanumeric char-
acters in
Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/EXIT
ba
rcode again.
Make a mistake? Scan the CANCEL barcode to abort and
not
save the entry string. You can then start again at the
beginning.
CANCEL
$CSNFF
~