Maintenance & Service Guide HP Compaq 8200 Elite All-in-One Business PC

4. Remove the memory module (see Memory on page 42).
5. Remove the drive access panel (see
Drive Access Panel on page 35).
6. Remove the stand (see
Stand on page 33).
7. Remove the optical drive (see
Optical Drive on page 37).
8. Remove the top panel (see
Top Panel on page 45).
9. Remove the rear cover (see
Rear Cover on page 48).
10. Remove the system board cover (see
System Board Cover on page 49).
11. Remove the power switch assembly cable. You do not have to remove the remaining cables.
12. Remove the front bezel (see
Front Bezel on page 75).
13. Disconnect the display cable (1) and the backlight cable (2) from the display panel.
NOTE: When disconnecting cables from the LG panel, you may need to remove Mylar before
disconnecting the cables.
Figure 6-57 Removing the display cable and backlight cables from the display panel (Samsung
panel shown)
14. Remove the four silver Torx screws that secure the display panel to the frame or brackets.
The LG panel mounts to a large frame using four screws - two on top, two on the bottom.
The Samsung panel mounts to two small brackets, one on each side. Each bracket is secured
by two screws.
78 Chapter 6 Removal and Replacement Procedures All-in One (AIO) Chassis