HP Z200 and Z400 Workstations - Front Fan and Holder Installation

Step 1—Preparing for component installation

NOTE: Computer models vary. All illustrations are examples only.

Accessing the internal components of the computer

1. If you need help preparing the computer for this installation, consult the removal and replacement

procedures in the service guide for your computer at

http://www.hp.com/support/manuals.

2. Power down the computer, and then disconnect the power cord.

3. Power down all external devices, and then disconnect them from the computer.

4. Remove the side access panel.

Step 2—Installing the front fan and fan holder

1. To have adequate clearance for installing the fan, remove any full-length expansion cards:

a. (Z400 only) If installed, remove the expansion card support by removing the two connecting

screws (1) and lifting up on the support (2).

Figure 1 Removing expansion card support (Z400)

ENWW

Step 1—Preparing for component installation