HP Z200 and Z400 Workstations - Front Fan and Holder Installation

5. (Z400 with hood sensor only) Insert the hood sensor into the slot provided on the fan holder/card

guide.

Figure 7 Inserting the hood sensor into the fan holder/card guide

6. Route the front chassis cables so that they will clear the fan holder/card guide:

●

Route the front USB and power switch cables along the bottom of the drive bay (1).

●

Route the speaker cable along the side wall of the chassis (2).

Figure 8 Routing the cables (Z400 shown)

ENWW

Step 2—Installing the front fan and fan holder