HP Z200 and Z400 Workstations - Front Fan and Holder Installation

7. Angle the fan holder/card guide assembly to one side to insert it into the chassis (1), and then
rotate the assembly so that it is parallel to the front of the chassis (2). Make sure that the fan cable
can reach the power receptacle on the system board.
CAUTION: Clamping a cable between the card guide and the chassis might damage the cable.
Figure 9 Inserting the fan holder/card guide assembly
8. Finish installing the fan holder/card guide assembly, as shown in the following illustration:
a. Slide the fan holder/card guide toward the front of the chassis (1).
b. Rotate the fan holder/card guide so that the bottom tabs snap into the grid on the chassis
first, followed by the top tabs (2).
c. Plug the front fan connector into the front chassis fan header on the system board (3).
NOTE: To locate system board components, see the service label on the side access panel.
8 Front fan and fan holder installation ENWW