Intel vPro Processor Technology Setup and Configuration for the HP Z1, Z210, Z420, Z620 and Z820 Workstations

23
8. Go into Intel AMT Configuration (Figure 25).
Figure 25. Intel AMT Configuration screen.
9. Select Manageability Feature Selection.
Default (and recommended) setting: Enabled
10. Select SOL/IDE-R/KVM.
a. Username and password. This option allows users and passwords to be
added from the WebGUI. If it is disabled, then only the administrator has
MEBx remote access.
Default (and recommended) setting: Enabled
b. Serial Over LAN (SOL).
Default (and recommended) setting: Enabled
c. IDE Redirection.
Default (and recommended) setting: Enabled
d. Legacy Redirection Mode. This option allows the Redirection feature to
work with the pre-AMT 7.0 remote consoles (need to set to Enabled).
Default (and recommended) setting: Disabled
e. KVM.
Default (and recommended) setting: Enabled
11. Select User Consent
a. User opt-in.
Default setting: User Consent is required for KVM session
Recommended setting: User dependent
b. Opt-in Configuration from remote IT.
Disable Remote Control of KVM Opt-in Policy – This option disables the
Remote User’s ability to select User OPT-IN Policy. In this case only the
local user can control the opt-in policy. Enable Remote Control of KVM
Opt-in Policy - Enables Remote User’s ability to select User OPT-IN Policy.
Default setting: Enabled Remote Control of KVM Opt-in Policy
Recommended setting: (User dependent)