User's Manual
Table Of Contents
- Get started with your HP iPAQ
- The Today screen
- Launch Getting Started
- Status icons
- Use the touch screen display
- Use shortcut menus
- Use the 5‑way optical navigation
- Use the main buttons on the HP iPAQ
- Use the on‑screen keyboard
- Know your device
- Customize your HP iPAQ
- Create a device name
- Specify owner information
- Change the regional settings
- Adjust the volume settings
- Adjust the ring tone and notification sounds
- Use the ringer/sound switch
- Customize screen settings
- Change the power management settings
- Adjust the brightness settings
- Connect to a computer
- Install and remove programs
- Set alarms and clocks
- Display the clock in the title bar
- Customize the shortcut key
- Adjust the speed for scrolling through items in a list
- Use the proximity sensor
- Protect your HP iPAQ with a password
- Use HP iPAQ Key Guard
- Use the device lock
- Battery‑saving tips
- Power Save Mode
- Use your HP iPAQ
- Check connection and signal strength
- Call features
- Call history
- Change the SIM PIN
- Change service settings
- Supported frequency bands
- Configure channels
WARNING! Removing the battery from your HP iPAQ before turning it off might corrupt data on your
HP iPAQ.
Power Save Mode
Activating the Power Save Mode helps conserve your HP iPAQ battery power until the next charging
cycle. The Power Save Mode will become active when the battery reaches 25% of the full charge level
and a warning is displayed on the screen. If you cancel this warning, another warning is displayed when
the battery drains to 10% of the full charge level and the device goes into the Power Save Mode.
When the device is in the Power Save Mode,
(Power Save Mode icon) is displayed at the top of the
screen. Power Save Mode will automatically turn off after charging your battery above the 25% level,
and all the adjusted system settings are restored.
To turn on Power Save Mode:
1. Tap Start > Settings > System > Power Save Mode.
2. Set the Power Save Mode option to On.
3. Tap ok.
To configure Power Save Mode:
1. Tap Start > Settings > System > Power Save Mode.
2. Select the required settings and tap ok.
TIP: You can also tap Advanced to adjust advanced settings for the Power Save Mode.
To turn off Power Save Mode:
1. Tap Start > Settings > System > Power Save Mode.
2. Set the Power Save Mode option to Off.
3. Tap ok.
NOTE: Another way to exit Power Save Mode is to follow the alert messages on your HP iPAQ
when it is in Power Save Mode.
Power Save Mode 31