User's Manual

Adjust the volume settings
Adjust the HP iPAQ sound volume. Increase or decrease the ringer volume and the clicking sound you
hear when you select program names and menu options.
To adjust the volume:
1. Tap the
(Speaker) icon at the top of the screen.
2. Move the system volume slider on the screen using the stylus or the Volume up/down key of your
HP iPAQ to establish the volume level.
3. To mute system sounds, tap Off.
TIP: To temporarily mute the system sounds, press the Volume up/down button on the side panel
of the device once.
You can also set a specific sound for a specific event.
To set sounds:
1. Tap Start > Settings > Personal > Sounds & Notifications.
2. On the Sounds tab, choose how you want to be notified by selecting the appropriate check boxes.
3. On the Notifications tab, in the Event list, tap an event name, and then choose how you want to
be notified by selecting the appropriate check boxes. You can choose from several options, such
as a special sound, a message, or a flashing light.
NOTE: Turning off sounds and the LED notification helps conserve battery power.
Adjust the ring tone and notification sounds
Change the ring tone and system sounds for incoming calls, alerts, and message notification.
To change ring tone and ring type:
1. Press the
(Answer/Send) key.
2. On the Dialer screen, tap Menu > Options… > Phone.
3. Tap the Ring type or Ring tone list.
4. Select the sound you want to use.
5. Tap ok.
Use the ringer/sound switch
You can use the ringer/sound switch to put your HP iPAQ in the vibrate mode. You will continue to
receive notifications and calls on your HP iPAQ. However, all sounds including the built-in speaker will
be switched off.
To enable the vibrate mode:
Customize your HP iPAQ 23