User's Manual

●
Headsets or earphones used with this device should comply with the headphone limits in EN
50332-2.
●
HP recommends using the headset delivered with your iPAQ (part number 455673-001) that is in
compliance with EN 50332-1.
Airline Travel Notice
Use of electronic equipment aboard commercial aircraft is at the discretion of the airline.
Medical Electronic Equipment
If you have a medical condition that requires you to use a pacemaker, hearing aid, or any type of medical
electronic equipment, consult the manufacturer of the equipment to determine if the medical equipment
is shielded from RF energy. Additionally, please seek advice from your physician about the potential
effects of RF interference from your HP iPAQ upon the medical device you are using. Turn off your
HP iPAQ in health care facilities or hospitals when there are posted restrictions requiring you to do so.
SAR Notice
THIS DEVICE MEETS INTERNATIONAL GUIDELINES FOR EXPOSURE TO RADIO WAVES.
Your mobile device is a radio transmitter and receiver. It is designed and manufactured not to exceed
the limits for exposure to radio frequency (RF) recommended by international guidelines (ICNIRP).
These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the
general population. The guidelines were developed by independent scientific organizations through
periodic and thorough evaluation of scientific studies. The guidelines include a substantial safety margin
designed to assure the safety of all persons, regardless of age and health.
The exposure standard for mobile devices employs a unit of measurement known as the Specific
Absorption Rate, or SAR. The SAR limit stated in the international guidelines is 2.0 W/kg*. Tests for
SAR are conducted using standard operating positions with the device transmitting at its highest certified
power level in all tested frequency bands. Although the SAR is determined at the highest certified power
level, the actual SAR of the device while operating can be well below the maximum value. This is
because the device is designed to operate at multiple power levels so as to use only the power required
to reach the network.
In general, the closer you are to a base station, the lower the power output of the device. Before a phone
model is available for sale to the public, compliance with the European R&TTE directive must be shown.
This directive includes as one essential requirement the protection of the health and the safety for the
user and any other person. The highest non-FCC SAR value for this device when tested for use at the
ear is 0.912 W/kg (10 g).
This device meets RF exposure guidelines when used either in the normal use position against the ear
or when positioned away from the body. When a carry case, belt clip or holder is used for body-worn
operation other than the HP belt clip supplied with the product, it should not contain metal.
* The non-FCC SAR limit for mobile devices used by the public is 2.0 Watts/Kilogram (W/kg) averaged
over ten grams of body tissue. The guidelines incorporate a substantial margin of safety to give additional
protection for the public and to account for any variations in measurements. SAR values may vary
depending on national reporting requirements and the network band.
126 Chapter 21 Regulatory notices