User Manual

WARNING! Use of controls or adjustments or performance of procedures other than those specified
herein or in the laser product’s installation guide may result in hazardous radiation exposure. To
reduce the risk of exposure to hazardous radiation:
●
Do not try to open the module enclosure. There are no user-serviceable components inside.
●
Do not operate controls, make adjustments, or perform procedures to the laser device other than
those specified herein.
●
Allow only HP Authorized Service technicians to repair the unit.
Power supply and power cord set requirements
Power supply class I grounding requirements
For protection from fault currents, the equipment shall be connected to a grounding terminal. Plug the
system power cord into an AC outlet that provides a ground connection. Substitute cords may not
provide adequate fault protection. Only use the power cord supplied with this product or a Hewlett-
Packard authorized replacement.
Brazil notice
Este equipamento deve ser conectado obrigatoriamente em tomada de rede de energia elétrica que
possua aterramento (três pinos), conforme a norma nbr abnt 5410,visando a segurança dos usuários
contra choques elétricos.
Denmark
Apparatets stikprop skal tilsluttes en stikkontakt med jord, som giver forbindelse til stikproppens jord.
Finland
Laite on liitettävä suojakoskettimilla varustettuun pistorasiaan.
Norway
Apparatet må tilkoples jordet stikkontakt.
Sweden
Apparaten skall anslutas till jordat uttag.
Power supply requirements
The power supplies on some products have external power switches. The voltage select switch
feature on the product permits it to operate from any line voltage between 100-127 or 200-240 volts
AC. Power supplies on those products that do not have external power switches are equipped with
internal circuits that sense the incoming voltage and automatically switch to the proper voltage.
For safety reasons, use only the AC adapter provided with the unit or an authorized replacement
adapter from Hewlett-Packard. Replacement part numbers may be found at
http://www.hp.com/cgi-
bin/hpsupport/index.pl.
For use in Norway
This product is also designed for an IT power system with phase-to-phase voltage 230V.
Power supply and power cord set requirements 25