User's Manual

Save your work and shut down the computer before adding or replacing a memory module or hard
drive.
If you are not sure whether the computer is off, turn the computer on by pressing the power button.
Then shut down the computer through the operating system.
Removing or replacing the service door
Removing the service door
Remove the service door to access the memory module slot, hard drive, and other components.
1. Remove the battery (see
Removing a battery on page 46).
2. With the service bay toward you, remove the 3 captive screws at the center of the unit and the 2
screws at the edge of the unit (1). Then remove the 2 screws in the middle of the service cover.
4 screws, total, have rubber covers which will need to be removed before the screws can be
accessed. (2).
3. Slide the service door toward the front of the computer (3) and lift (4) to remove the cover.
Replacing the service door
Replace the service door after accessing the memory module slot, hard drive, regulatory label, and
other components.
1. Set the service cover down in place (1), taking care to align it properly, and then slide it toward
the battery bay until the service door snaps into place (2).
56 Chapter 8 Drives ENWW