HP 1:10Gb Ethernet BL-c Switch for c-Class BladeSystem Browser-based Interface Reference Guide

Configuring the switch
142
The following table describes the Switch Management Processor Configuration (SNMP) controls:
Table 96 Switch Management Processor Configuration (SNMP) controls
Control Description
SNMP System Name Configures the name for the system. The name can have a maximum
of 32 characters.
SNMP Location Configures the name of the system location. The location can have a
maximum of 32 characters.
SNMP Contact Configures the name of the system contact. The contact can have a
maximum of 32 characters.
SNMP Read Community String Configures the SNMP read community string. The read community
string controls SNMP “get” access to the switch. It can have a
maximum of 32 characters. The default read community string is
public.
SNMP Write Community String Configures the SNMP write community string. The write community
string controls SNMP “set” and “get” access to the switch. It can have
a maximum of 32 characters. The default write community string is
private.
SNMP state machine timeout (1-30 minutes) Sets the timeout value for the SNMP state machine.
Send SNMP Auth. Failure Traps? Enables or disables the use of the system authentication trap facility.
The default setting is disabled.
Switch Management Processor Configuration buttons
The following table describes the Switch Management Processor Configuration buttons:
Table 97 Switch Management Processor Configuration buttons
Control Description
Submit Sends this form to the switch. Any configuration changes are placed in the “pending”
state and do not take effect until the toolbar Apply command is given.
Diff Shows any pending configuration changes.
Diff Flash Compares new configuration with the flash configuration.
Revert
Removes pending configuration changes between apply commands. Use this
command to restore configuration parameters set since last apply command.
Revert Apply
Removes pending configuration changes between save commands. Use this command
to restore configuration parameters set since last save command.