HP 1:10Gb Ethernet BL-c Switch for c-Class BladeSystem Browser-based Interface Reference Guide

Configuring the switch
159
Table 106 Switch Port Configuration controls
Control Description
PVID Tagging Disables or enables VLAN tag persistence. When disabled, the VLAN
tag is removed from packets whose VLAN tag matches the port PVID. The
default value is enabled.
Port STP Turns Spanning Tree On or Off for this port.
Default Port VLAN ID (1-4095) Sets the default VLAN number which will be used to forward frames
which are not VLAN tagged.
The default number is 1.
NOTE: VLAN 4095 is reserved for switch management.
Flow Control Sets the flow control. The choices include:
• Receive flow control
• Transmit flow control
• Both receive and transmit flow control (default)
• No flow control
Autonegotiation Enables or disables auto negotiation for the port.
NOTE: Ports 19-21 are set to 10000 Mbps, and cannot be set to auto-
negotiate.
Speed Sets the link speed. Not all options are valid on all ports. The choices
include:
• “Any,” for automatic detection (default)
• 10 Mbps
• 100 Mbps
• 1000 Mbps
NOTE: Ports 19-21 are set to 10000 Mbps, and cannot be changed.
Duplex mode Sets the operating mode. Not all options are valid on all ports. The
choices include:
• “Any,” for auto negotiation (default)
• Full-duplex
• Half-duplex
NOTE: Ports 19-21 are set to full duplex, and cannot be changed.
Enable/Disable sending Link UP/Down
Trap
Enables or disables the sending of SNMP link up and link down traps.
The default setting is enabled.
Port Name Sets a name for the port. The assigned port name appears next to the
port number on some information and statistics screens.
Multicast Threshold Enables or disables multicast threshold limit.
Limits the number of multicast packets to the specified value. If disabled
(dis), the port forwards all multicast packets.
Multicast Threshold Rate (0-262143) Configures the threshold rate for multicast packets, in packets per
second.