HP 1:10Gb Ethernet BL-c Switch for c-Class BladeSystem Browser-based Interface Reference Guide

Configuring the switch
224
RIP Interfaces Configuration
To display the following form, select Layer 3 > Routing Information Protocol > Routing
Information Protocol (click the underlined text, not the folder).
RIP is used for configuring Routing Information Protocol parameters. This option is turned off by default.
NOTE: Do not configure RIP version 1 parameters if your routing equipment uses RIP version 2.
The following table describes the RIP Interfaces Configuration controls:
Table 159 RIP Interfaces Configuration controls
Control Description
Search Range To search for a RIP interface, enter a range of interface numbers in the From and To
fields.
Search Options To focus the search for a VLAN, enter optional search parameters:
• RIP Version
• RIP state
Fields that have a value of “any” are ignored during the search.
Choose a search operation:
• or: Search for RIP interfaces specified in the search range that meet any of the
criteria entered.
• and: Search for RIP interfaces specified in the search range that meet all of the
criteria entered.
Click Search to display RIP interfaces that fit the range and meet the criteria entered.