HP 1:10Gb Ethernet BL-c Switch for c-Class BladeSystem Browser-based Interface Reference Guide

Dashboard
70
Table 45 RIP Interfaces Dashboard controls
Control Description
Poisoned Reverse Displays whether Poisoned Reverse is enabled or disabled.
Triggered Updates Displays whether Triggered Updates is enabled or disabled.
Multicast Updates Displays whether Multicast Updates is enabled or disabled.
Metric Displays the route metric for the interface.
Auth Type Displays the authentication type for the interface.
Auth Key Displays the authentication key for the interface.
Split Horizon Displays whether Split Horizon is enabled or disabled.
Virtual Router Group Operation
To display the following form, select Layer 3 > VRRP > General.
The following table describes the VRRP General controls:
Table 46 Virtual Router Group Operation controls
Control Description
Set Virtual Router
Group to Backup
Forces the master virtual router group into backup mode. This is generally used for passing
master control back to a preferred switch once the preferred switch has been returned to
service after a failure. When this command is executed, the current master gives up control
and initiates a new election by temporarily advertising its own priority level as 0 (lowest).
After the new election, the virtual router forced into backup mode by this command will
resume master control in the following cases:
• This switch owns the virtual router (the IP addresses of the virtual router and its IP interface
are the same)
• This switch’s virtual router has a higher priority and preemption is enabled.
• There are no other virtual routers available to take master control.