HP 1:10Gb Ethernet BL-c Switch User Guide

Technical specifications 28
Setting Value
Switch Config file on next boot Active
Display Hostname (sysName) in CLI
prompt
Disabled
Idle timeout 5 minutes
Telnet status Enabled
Telnet port 23
Web status Enabled
Web port 80
Backpressure Disabled
Port state Enabled
Port speed/duplex Auto
Flow control Receive & transmit
STP STG 1—Enabled with default VLAN (VID=1)
Port 1-16 (server ports) STP—Disabled at port level
STG 2-16—Disabled
Bridge Max Age 20 seconds
Bridge Hello Time 2 seconds
Bridge Forward Delay 15 seconds
Bridge Priority 32768
MAC Address Aging Time 300 seconds
Port Priority 128
Path Cost 4
Static VLAN Entry Default VLAN (VID = 1)
Port VID 1 for all ports
Port Trunking Trunk group 1, empty and disabled
Port Trunking Load Sharing Algorithm The algorithm selects the following as forwarding ports for
forwarding traffic:
1 For forwarding IP Packets—modulus of XOR of last 3 bits of
source and last 3 bits of Destination IP address
2 For forwarding non-IP packets—modulus of XOR of last 3
bits of source and last 3 bits of Destination MAC address
3 For forwarding broadcast, multicast packets, and unknown
unicast packets—the lowest active port number in the trunk
group
Port Mirroring-Mirror Status Disabled
Port Mirroring-Mirror Port None selected
Port Mirroring-Mirror Port Traffic Direction None selected
Port Mirroring-Monitoring Port None selected
SNMP Read/write
SNMP System Name None