Configuration Guide for A7000 dl T1 and E1 WAN Interfaces 2005-12

Understanding SROS Queuing Methods Physical Interface Configurations (T1, E1, and Ethernet)
5991-3823 3
Physical Interface Configurations (T1, E1, and Ethernet)
To begin configuring physical interfaces, you must first activate the appropriate interface configuration
mode from the Global configuration prompt. For example, enter the following commands to activate the
interface configuration mode for the first T1 interface on a T1 module inserted in slot 1:
ProCurve>enable
ProCurve#config terminal
ProCurve(config)#interface t1 1/1
ProCurve(config-t1 1/1)#
All interfaces are disabled by default and must be activated using the no shutdown command. Interfaces
will not be able to pass data until this command is entered.
Interfaces can also be configured using the Web GUI. To activate the configuration page for a physical
interface located in the unit, click on the Physical Interfaces link under the System heading in the
navigation bar on the left side of the screen (see below). Select the physical interface to configure from the
list.
Note
Interface Modules use a slot/port notation for interface identification (e.g., t1 1/1). All
non-modular interfaces built into the base unit are identified using 0 as the slot number
(e.g. eth 0/1).