Quick Configuration Guide A7000 1xSerial Module (J8458A) 2005-04

6 www.procurve.com 5991-2116
The following steps show how to access the Telnet configuration parameters and change the
password. For this example, replace the underlined word
with a password of your choosing. The
ProCurve Secure Router supports five Telnet sessions (0 through 4).
1. Verify that the prompt of your unit displays (config)#.
2. Enter line telnet 0 4 to change the configuration parameters for the Telnet session. Your
prompt should now display (config-telnet-0-4)#.
3. Enter password word
to change the login password for the Telnet session.
4. Enter exit to return to the Global Configuration mode.
1. Verify that the prompt of your unit displays (config)#.
2. Enter exit to leave configuration mode.
3. Enter copy running-config startup-config to save the current configuration to memory. This
command may be abbreviated as copy run start.
4. Enter exit to close the configuration session.
The ProCurve Secure Router is now configured and operational. Complete the installation by
connecting the appropriate cables to the serial and Ethernet networks. Please refer to the
ProCurve Secure Router Installation Guide for more details on pinouts and cabling.
Configure Telnet Access
Note
An enable security mode password and the Ethernet port parameters must be defined
before configured Telnet sessions are activated. Refer to
Configure the Ethernet Port
Parameters
on page 2 and Set Enable Security Mode Password on page 5 for more
information.
Save the Configuration
Complete the Installation