Configuration Guide for A7000 dl T1 and E1 WAN Interfaces 2005-12

Configuring the Frame Relay Interfaces (and Sub-Interfaces) Understanding SROS Queuing Methods
8 5991-3823
The following commands specify the configuration parameters required for a standard Frame Relay
sub-interfaces:
ProCurve(config)#interface fr 2.16
ProCurve(config-fr 2.16)#frame-relay interface-dlci 16
ProCurve(config-fr 2.16)#frame-relay bc 768000
ProCurve(config-fr 2.16)#frame-relay be 768000
ProCurve(config-fr 2.16)#ip address 192.168.72.1 /30
ProCurve(config-fr 2.16)#no shutdown
ProCurve(config-fr 2.16)#exit
L2 protocol interfaces are created in the Web GUI on the configuration page for the physical interface to
which they are bound. For example, to create the Frame Relay interface to bind to a T1 interface, activate
the T1 interface configuration page and specify Frame Relay in the Encapsulation section:
Note
Labeling the Frame Relay sub-interfaces using the DLCI (such as 1.16 indicating a DLCI
of 16) is useful for quickly determining (from a configuration printout) which sub-interface
corresponds to which PVC. The Web GUI automatically uses the configured DLCI for the
sub-interface label.
Create the
L2 Protocol
Interface