Quick Start Guide A7000 dl 2xISDN BRI S/T Module (J8457A) 2006-05

ManualsBrandsHP ManualsComputer AccessoriesHP 1-port T1 dl Module

Quick Start Guide 5991-3793

ProCurve Secure Router dl 2xISDN BRI S/T Module

J8457A

PECIFICATIONS

Operating Mode Independent TE mode of operation for each interface

Features Line Rate: Network support for 128 kbps (2 B channels)

per interface

Switch Compatibility: Euro-ISDN

Test Capability: Local and network loopbacks

Compliance FCC Part 15 Class A, EN 55022 Class A, EN 61000-3-2,

EN 61000-3-3

ACIF S031, ETSI TBR 3

AS/NZS 60950, EN 60950

Physical Dimensions: 6.99 cm (2.75 in) W x 10.80 cm (4.25 in) D

Operating Temperature: 0°C to 50°C (32°F to 122°F)

Relative Humidity: Up to 95 percent, noncondensing at

30°C (86°F)

Non-Operating Temperature: -20°C to 70°C (-4°F to

158°F)

Non-Operating Relative Humidity: Up to 95 percent,

noncondensing at 30°C (86°F)

Altitude: Up to 3.05 km (10,000 ft)

INSTALLATION INSTRUCTIONS

Warning

For ProCurve Secure Router modules with outside plant

connections, ensure that all cables are removed from the

module before installing or removing it from the router

chassis.

1. Remove power from the unit.

2. Slide the ProCurve Secure Router dl 2xISDN BRI S/T Module into the

option slot until the module is firmly seated against the chassis.

3. Secure the screws at both edges of the module.

4. Connect the cables to the associated device(s).

5. Complete the installation of the base unit.

6. Restore power to the unit.

ISDN S/T CONNECTION PINOUT

Pin Name Description

1,2 — Unused

3 R1 Network-Receive (Ring 1)

4 R Network-Transmit (Ring)

5 T Network-Transmit (Tip)

6 T1 Network-Receive (Tip 1)

7,8 — Unused

Note

For safety information for the routers and all modules,

please refer to the safety and ESD precautions in the

ProCurve Secure Router Installation Guide included

in your router shipment.

Summary of content (2 pages)

PAGE 1
Quick Start Guide 5991-3793 ProCurve Secure Router dl 2xISDN BRI S/T Module J8457A INSTALLATION INSTRUCTIONS Warning For ProCurve Secure Router modules with outside plant connections, ensure that all cables are removed from the module before installing or removing it from the router chassis. 1. Remove power from the unit. 2. Slide the ProCurve Secure Router dl 2xISDN BRI S/T Module into the option slot until the module is firmly seated against the chassis. 3.
PAGE 2
Quick Start Guide 5991-3793 ProCurve Secure Router dl 2xISDN BRI S/T Module J8457A 2XISDN BRI S/T MODULE COMMANDS alias isdn switch-type [basic-net3] Populates the ifAlias OID (Interface Table MIB of RFC2863) for this interface for use by the SNMP management station. Configures the unit to replace caller ID information with a user-specified number. Use the no form of this command to disable any caller ID overrides. Specifies the ISDN signaling type configured on the BRI interface.